DYNTEK Spindle
 
 

Dyntek Spindle is often used for the fixing of MetalLath / StripMesh onto wall prior to plastering in particular crack-prone areas between concrete and brick/blockwork.

Other applications include for fastening of fibre-glass wool in hot and cold insulation works.

Pin manufactured from aluminium alloy (soft) and perforated square base/round washer from galvanised steel.




Benefits

Safe, convenient to use and fast bonding when used with Dyntek Adhesive SB50.

Compares favourably against concrete nail since Spindle does not penetrate into brick/blockwork thus reducing chances of cracks and water seepage through brick/blockwork.

 

Product Code
Pin Length (mm)
Spindle Adhesive
SPP38
38
To fasten, use
Dyntek Adhesive SB50 (200g/tube)
sold separately
SPP65
65
SPP100
100
SPA38
38
Supplied with self-adhesive
base plate
SPA65
65
SPA100
100

All models listed above are manufactured using aluminium alloy pins and supplied in 1000 pieces/box complete with washers.
SPA series is not recommended for use in in moist or dusty site conditions.

 

Installation Notes

  1. Apply Dyntek Adhesive SB50 to perforated base of Spindle.
    (Skip this step for Self-adhesive Spindle eg. SPA38)
  2. Attach Spindle onto clean and dry surface area of installation, including mesh/plaster.
  3. Repeat steps 1 and 2, placing Spindles at 300mm centres at area of installation, including mesh/plaster.
  4. Allow adhesive to set sufficiently before placing material (mesh or wool) over Spindles.
  5. Insert washer over Spindle, down onto the material and bend excess length of pin over washer so that the material (mesh or wool) is secured firmly.


Dyntek Pte Ltd 2008-2011 © All Rights Reserved.